Broadhead Sharpener

Description

This stone is made from a synthetic abrasive material and is used in the same manner as a diamond or natural Arkansas bench stone. The extra-coarse side of the stone (100 grit) is used for aggressive removal of metal and will sharpen a dull or damaged blade very quickly. The other side of the stone (240 grit) is for less agressive removal of metal and should be used for sharpening somewhat dull blades that just need a quick touch-up or for smoothing the cutting edge after sharpening on the coarse side. It is excellent for use on pocket knives, sport knives, tactical knives, or other cutting tools.

Specifications

Instructions

Broadhead:

Always keep fingers inside the protective hand guard when sharpening or injury could occur. Secure your boadhead so that it doesn't move. Place the V-groove that is created by the two tungsten carbide cutting heads over your broadhead blade. Some broadheads may need to be disassembled in order to sharpen entire length of blade. Hold the sharpener at a 90-degree angle to the broadhead blade and with light pressure pull the cutting heads down the blade until sharp. Three or four strokes are all it will take. Repeat steps on each blade.

Broadhead Wrench Instructions:

  1. Do not put your fingers inside hand guard when removing your broadhead or injury could occur. Keep fingers on the outside of sharpener handle when losing or tightening your broadhead. When using the wrench, select the slot that fits your broadhead. Slide broadhead into slot until snug and then loosen or tighten by rotating the handle. Do not over-tighten. 1/2" to 1" of the blade to extend past the edge of your flat surface.
  2. Position the head of the sharpener at a 90-degree angle to the knife's cutting edge. Draw the sharpener across the blade from the heal to the point while applying a light downward pressure. Repeat this process 3 or 4 times until your knife is sharp.
  3. Reversible and Replaceable Carbide Blades and Ceramic Stones – When the carbide blades or ceramic stones stop removing metal from the knife blade, they can be rotated for use on the other side or replaced. To rotate or replace, remove the two screws and the plastic cover. Remove the blades or stones and rotate or replace. If rotating blades or stones, rotate 180 degrees and place the top blade or stone into the bottom slot, and the bottom blade or stone into the top slot. Replace the cover and two screws.

Care:

Always clean your sharpener after use. Clean with a damp cloth or non-abrasive brush. Do not rinse with water.

SKU YHBHS
Brand Smith's Abrasives
Shipping Weight 0.0010kg
Shipping Width 0.001m
Shipping Height 0.001m
Shipping Length 0.001m
Shipping Cubic 0.000001000m3

Be The First To Review This Product!

Help other The Gun Shed users shop smarter by writing reviews for products you have purchased.

Write a product review